The RMS 3,000 Gallon Rainwater Harvesting Package arrives pre-plumbed and ready for installation, reducing on-site labor and simplifying the installation process. Internal components are factory assembled, and piping is pre-cut to the required lengths to help streamline setup. This package is designed for below-ground installation and provides a complete rainwater harvesting solution for residential and commercial applications.
Note: Secondary post-tank filtration and disinfection equipment are not included in this package. Additional components may be required depending on the intended application and system design.
Price (Parallel Tank Layout): $10,658.00 + Freight
Contact RMS for a shipping quote.
Frequently Asked Questions
Does this package arrive ready to install?
Yes. The RMS 3,000 package is pre-plumbed at the factory, which significantly reduces on-site labor. Internal components are assembled and piping is pre-cut, so installation is straightforward once the excavation is complete.
Is this system suitable for residential and commercial use?
Yes. The package is designed for both residential and commercial applications that require below-ground rainwater storage and delivery.
What is not included in this package?
Secondary post-tank filtration and disinfection equipment are not included. Depending on your intended use — particularly potable or non-potable indoor applications — additional treatment components may be required. Contact RMS to discuss what your specific system design calls for.
Does the pump require a special electrical connection?
The Grundfos SBA 3-45 submersible pump runs on 115V / 1 Phase / 60 Hz, which is standard residential and light commercial power. No special electrical service is required in most installations.
What happens if the water level gets too low?
The pump includes an integrated normally open low-water protection switch. If water drops below a safe operating level, the switch cuts power to the pump automatically, preventing damage from dry-run conditions.
Can the two tanks be installed in different configurations?
The base price reflects a parallel tank layout. If your site requires a different configuration, contact RMS directly — they can advise on options and any impact on pricing or freight.
How is the system filtered before water enters the tanks?
Rainwater passes through the WISY WFF150 Vortex Fine Filter before entering storage. The vortex design separates fine particles and debris without clogging, keeping the tanks clean without frequent maintenance. A smoothing inlet then diffuses the flow to prevent turbulence inside the tank.
How do I get a shipping quote?
Freight is not included in the listed price of $10,658.00. Contact RMS directly for a shipping quote based on your project location.


Reviews
There are no reviews yet.